![]() ![]() access-list voip-traffic remark ]Īccess-list voip-traffic extended permit ip 10.0.0.0 255.255.255.0 host 1.2.3.4 The numbers used here could be drastically different depending on your requirements. Numbers used for queue-limit and tx-ring-limit determined using the worksheet in the configuration guide and then massaged. By using a simple ACL we can verify the service-policy later on with show service-policy flow. Another option is to use IP DSCP if the phones are marking. Using an extended access-list with source and destination IP for matching VoIP traffic.Based on a maximum delay of 200 milliseconds between the VoIP endpoints.We can't "prioritize" incoming traffic unless you control that path as well. Note that this is only in the out direction. Based on a need to handle 10 calls at a time (87.5 Kilobits per second * 10 = 875 Kilobits per second).Based on a 218 byte average complete Ethernet frame size per voice payload interval.Based on G.711 voice codec 87.5 kilobits per second Ethernet layer 2 data rate (includes all overheads). ![]()
0 Comments
Leave a Reply. |